Dp Dual Trac 20 Assembly Manual <DIRECT WORKFLOW>

Use the included multi-hex tool on the rear roller bolts.

[Top Crossmember Pulley] ---------> [Floating Pulley] ---------> [Weight Stack Top] | | v v (Lat Bar Attachment) (Lower Cable System) Use code with caution. The Top (Lat) Cable System Dp Dual Trac 20 Assembly Manual

: The tracks use a V‑groove + ball bearing interface. If you tighten the carriage’s set screw (often labeled “C”) before inserting the bearing race, you will jam the vertical travel. The manual shows an exploded view of the bearing race sliding first , then the screw. In practice, 30% of user forum complaints about “stiff vertical adjustment” trace back to reversing these two sub‑steps. Use the included multi-hex tool on the rear roller bolts